Good
morning/Afternoon or Evening where ever you are around the world
So I’m attempting to roll out IE 9 via Kaseya but it has been no joy for me 
- I schedule the patch KB982861 to be installed, but then nothing seems to
happen, all I see is that the patch goes into the pending queue and then after
a few minutes gets relocated to the User Not Ready queue?
- I've checked the command line and the switch being used for IE9 is /quiet
/norestart which would indicate to me that it requires no user interaction?
- The patch has been approved and it’s not listed in the KB override list either
- Running windows update on the workstations works fine and I can install IE9
from there with no problems, can also install IE9 by downloading the installer
from MS website
- But when trying to run it via Kaseya it just says User Not Ready?
- I've tried installing all patches through Windows Updates and left IE9 there,
than ran it via Kaseya as I hopped maybe there were some prerequisite patches
missing and that it was due to that reason, after patching the workstation
fully while excluding IE 9 Kaseya is still stating User Not Ready?
- Rebooted workstations a number of times, post install and pre install and that
makes no difference
- Workstations are part of the correct memberships I've checked this a number of
times, even made a new test membership which also results in the same message
User Not Ready
- Tried Changing "File source" from "File server" to
"Internet" this also made no difference
- I've run the install package on workstation via CMD using the /quiet /norestart and once the workstation is rebooted it installs fine
- Anyone thats successfully deployed IE 9 via patch management that could possibly point me in the right direction would very much appreciated